DAQ system FRM11 Manual do Utilizador descarregar pdf (Página 19)

eCard-FRM11 User’s Manual (Rev 2.2)

-19- http://www.daqsystem.com

6.2 UART Tx/Rx Test

At the above stage, make the image frame simulator to send UART data to ECard-FRM11 board

periodically.

Step 1 : Press the “UART init” button to initialize the UART and then press the “Start Timer” to get

the UART data from the Image Frame Simulator. Then the gotten data are displayed on the

editor box below the button.

Step 2 : Write the data to the editor box beside the “Send Serial Data” button and press the “Send

Serial Data” button to send it to the Image Frame Simulator via the UART. Compare the

data on the editor box with that of the Image Frame Simulator.

6.3 CC Output Test

Make all the output port “1/0” using “DIO Write” editor box of the test program, after check the

output state using the oscilloscope. (You need to prepare some external circuit for identification.)

1 2 ... 14 15 16 17 18 19 20 21

Sem comentários

DAQ system FRM11 Manual do Utilizador Página 19